|
INITIAL SLOT MACHNE SETUP INSTRUCTIONS
|
| Before you can setup your
machine, you have to get it out of it's shipping crate. There are
many staples holding the crate together. Remove the top using a hammer
and a screwdriver or a pry bar. Then remove one side panel the same way.
With a side panel and the top gone the machine will come out of the
crate. Now you can begin to set up the machine. If a stand is going
to be used, it must be capable of holding 250 lbs or more without
collapsing. Open the machine door by moving the sliding lock lever
(Right side of machine) all the way up. (Close the door by reversing
this process.) (You may have to slightly lift the door up or down in
order to lock the lever all the way in the down position) -You will find
that the coin change/service lamp that is normally attached to the top
of the machine may have been removed and placed inside the machines coin
hopper for shipping purposes. It attaches to the top of the machine with
the 2 machine screws that are threaded into the candle. - You will need
to open the door on the machine and remove the top glass in order to
gain access to the under side where the candle mounts. You will find a
white colored quick connect plug in the area behind the top glass that
the lamp will plug into. Your jackpot reset key has been placed into the
reset switch lock located on the left side of the machine. You will only
use the reset key to reset the machines jackpot alarm when someone gets
lucky enough to get a jackpot or when changing games. (Otherwise you
will not need to turn this key)
You should notice that we
left a coin in the coin comparator which is located in the door of the
machine. This coin must remain in place or your machine will not accept
coins and you will get a tilt error code or the coin will jam. You will
also find the power cord inside the hopper. Route the power cord thru a
small opening in the back/bottom right side and plugs into a standard
110 volt outlet. The power switch is just inside the door opening (Right
side) - There’s also a small white test switch located there. You don’t
need to touch that. Initially when the machine is powered on it will
initialize a self test and the reels will spin up. Anytime the door is
opened and closed it may or may not do the same reel spin test.
Try to keep the hopper full
of coins at all times. If you cash the machine out and run out of coins
before you run the credit counter down you will get a 3300 error on the
display which is cleared by adding quarters to the hopper and closing
the door again
The only maintenance you
should experience are normal wear things like replacing burned out light
bulbs and the occasional coin jam which is corrected by removing the
jammed coin(s) in the coin comparator. Another common problem is the
Bill Vallidator cash box is not inserted all the way or is mis-aligned
which will cause your Bill Vallidator NOT to function. Be sure it is
inserted sqaurely and pushed all the way in place.
The tilt codes that you will
run into are reset and cleared by opening and closing the machine door.
There is an explanation of common error codes on the inside of the
machine door for you to refer to if you need to. Have fun with your slot
machine and if you should have any questions or concerns, please contact
us so we can help. Once again, we thank you for choosing us to make your
purchase. - Should you have any questions regarding the setup of your
machine, please give us a call and we will do our best to help you out
over the telephone. 95% of all problems can be resolved over the phone.
The remaining problems could be caused by the machine being banged
around while in transit and might require a replacement part be sent to
you. This is very rare but it can and does happen. Don't panick! This is
a casino slot machine and is very reliable. Thank you for your Business! |
